MoTeC M1 License - JRR Subaru STi 2008 - 2016

MoTeC M1 License - JRR Subaru STi 2008 - 2016
Click to enlarge
Price: $750.00
Product ID : JRR 23194
E-mail to a friend

Purchase

Description

JRR Subaru STi 2008-2016 firmware license for MoTeC M1 ECU

  • You can purchase just the JRR Subaru STi firmware license - perfect for MoTeC dealers

  • This firmware package suits 2008-2016 Subaru STi vehicles

  • May support other Subaru models which feature the EJ25 engine and CAN Bus communications.

  • Targeted package specific to one engine saves you money versus buying GPR!

  • Available for the M130 and M150 ECU. M170 and M190 version available by special order.

This firmware is based upon MoTeC GPR package and includes the following features:


  • Includes full DCCD active differential control - controls differential directly from the M1 ECU (some wiring required)

  • Full integration with Subaru STi OEM CAN Bus - maintains proper vehicle operation and dash functionality

  • Supports the factory cruise control including the steering wheel controls

  • iDrive switch can be used for any driver switch function in the M1 (use for boost/throttle/fuel trim/anti lag maps/etc)

  • Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

  • Supports running two separate fuel systems - each running a different type of fuel

  • Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

  • CO2/Wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

  • Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

  • Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware).

  • Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy

  • Supports the use of third party lambda controller with 0-5v output

  • Supports momentary buttons

  • Supports direct input from a MoTeC/Racegrade CAN keypad

  • Firmware is specific to the engine/model selected. To change to a different engine requires purchasing a different firmware license. Multiple firmware licenses can be installed on a single ECU.

  • Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 firmware does not come with tuning support. We are happy to quote you tuning for your particular setup, we can refer you to someone in your area, or if you want to DIY (and lack the experience) then we can also quote a training session.

  • This firmware is for closed course competition vehicles only. It does not meet federal emissions requirements.


Base Calibrations - For start up only. Proper tuning is required for your car. Use at your own risk!!!

Product Reviews

Login or Register to write the first review.