JRR Mitsubishi Evolution 4G63 firmware license for MoTeC M1 ECU
If you are a MoTeC dealer or already own an M1 ECU, you can purchase just the firmware license - no ECU purchase required
This firmware package suits all 4G63 equipped Mitsubishi Evo, as well as other 4G63 engines which use the same crank and cam trigger
Targeted package specific to one engine saves money versus buying GPR
Available for the M130 and M150 ECU. M170 and M190 version available by special order
This firmware is based upon MoTeC GPR package and includes the following features:
Includes full ACD control - control the center differential system directly from the M1 ECU (some wiring required)
Supports the OE cable throttle/stepper idle control motor or drive by wire conversion
Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content
Supports running two separate fuel systems - each running a different type of fuel
Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure
CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure
Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback
Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)
Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy
Supports the use of third party lambda controllers with 0-5v output
Supports momentary buttons
Supports direct input from a MoTeC/Racegrade CAN keypad
The lower price (compared to GPR) is due to this firmware being locked to the OE engine (unless otherwise noted). Locking is done by hard coding the crank and cam trigger pattern, cylinder number and firing order in the firmware. To change to a different engine or non stock trigger pattern requires purchasing a different firmware license. Multiple firmware licenses can be installed on a single ECU.
Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 firmware does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training.
This firmware is for closed course competition vehicles only. It does not meet federal emissions requirements.
JRR Mitsubishi Evolution X firmware license for MoTeC M1 ECU If you are a MoTeC dealer or already own an M1 ECU, you can purchase just...View full product details
JRR Universal Motorsport firmware license for MoTeC M1 ECU If you are a MoTeC dealer or already own an M1 ECU, you can purchase just the...View full product details
JRR Subaru STi 2008-2016 firmware license for MoTeC M1 ECU If you are a MoTeC dealer or already own an M1 ECU, you can purchase...View full product details