Dodge Viper Gen 4 M150 PNP Kit

JRR Dodge Viper 2008-2010 MoTeC M150 PNP Kit

• This full standalone kit replaces the stock ECU and provides a powerful tuning solution. The M150 kit plugs right in to your Viper and includes a start up calibration customized to your setup

• This kit fits 2008-2010 Dodge Viper vehicles

• Full integration with OE dash display, body electronics
  

• Supports traction control with adjustable slip targets
  

• Supports cruise control - just add suitable control switches

• Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

• Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

• CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

• Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

• Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)

• Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy

• Supports the use of third party lambda controllers with 0-5v output

• Supports momentary buttons

• Supports direct input from a MoTeC/Racegrade CAN keypad

• Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 kit does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training.

• This ECU kit is for closed course competition vehicles only. It does not meet federal emissions requirements.