Mitsubishi Evo X M1 PNP Kit

JRR Mitsubishi Evo X M1 PNP Kit

• This full standalone kit replaces the stock ECU and provides a powerful tuning solution. Available in M130 and M150 variants, this kit plugs right in to your Mitsubishi Evo X and includes a start up calibration customized to your setup

• This kit fits 2008-2016 Mitsubishi Evo X, manual and SST gearbox models

• Full integration with Mitsubishi Evo X OE CAN bus - maintains proper vehicle operation and dash functionality

• Supports the OE ACD active center differential ECU, or optionally the ACD components can be wired to the M1 ECU and full mapping of the ACD system can be done from within M1 Tune

• Supports the factory cruise control, using the OE steering wheel controls

• Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

• Supports running two separate fuel systems - each running a different type of fuel

• Two stage nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

• CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

• Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

• Boost aim strategy has been revised with flexible table setup options

• Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy

• Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)

• Supports the use of AEMnet lambda devices, as well as lambda controllers with a 0-5v signal output

• Supports direct input from a MoTeC/Racegrade CAN keypad

• Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 kit does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training

• This ECU kit is for closed course competition vehicles only. It does not meet federal emissions requirements.