Mitsubishi Evo 8 M130 PNP Kit

JRR Mitsubishi Evo 8 M130 PNP Kit

• This full standalone kit replaces the stock ECU and provides a powerful tuning solution. The M130 kit plugs right in to your Mitsubishi Evo 8 and includes a start up calibration customized to your setup

• This kit fits Mitsubishi Evo 8 with 4 plug ECU. It may also fit Evo 4 - 7 with minor wiring modification. Pin out can vary depending on original market car was sold in.

• Supports the OE ACD active center differential ECU, or optionally the ACD components can be wired to the M1 ECU and full mapping of the ACD system can be done from within M1 Tune

• Supports the OE cable throttle/stepper idle control motor or drive by wire conversion

• Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

• Supports running two separate fuel systems - each running a different type of fuel

• Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure

• CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

• Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

• Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)

• Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy

• Supports the use of third party lambda controllers with 0-5v output

• Supports momentary buttons

• Supports direct input from a MoTeC/Racegrade CAN keypad

• Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 kit does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training

• This ECU kit is for closed course competition vehicles only. It does not meet federal emissions requirements.