MoTeC M1 Firmware: JRR Polaris RZR XP Engine Swap

JRR Polaris RZR XP Engine Swap firmware licenses for MoTeC M1 ECU

  • If you are a MoTeC dealer or already own an M1 ECU, you can purchase just the firmware license - no ECU purchase required

  • Firmware licenses available for the following Polaris RZR/engine swap configurations:

    • XP with Arctic Cat Z1 swap
    • XP with Yamaha Apex swap
    • XP with Yamaha Nytro swap

Base Calibrations:

This firmware is based upon MoTeC GPR and includes the following features:

  • Complete integration with Polaris CAN bus - maintains full OE vehicle operation and dash functionality (stock ECU not needed)

  • Input for optional drive belt temperature sensor - including warning system and limiter

  • Full control of all engine tuning parameters including fuel, timing, boost, launch, and more with live tuning via supplied ethernet cable

  • Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content

  • Staged injection - supports two injectors per cylinder, including dual fuel systems

  • 2 stage nitrous control - various parameters supplied to control nitrous systems including bottle heater relay control based on nitrous pressure

  • Integrated CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure

  • Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback

  • Supports the use of AEMnet lambda devices, as well as lambda controllers with a 0-5v signal output

  • Supports most common injectors, coils, sensors and actuators
  • Supports direct input from a MoTeC/Racegrade CAN keypad

  • The lower price (compared to GPR) is due to this firmware being locked to the OE engine (unless otherwise noted). Locking is done by hard coding the crank and cam trigger pattern, cylinder number and firing order in the firmware. To change to a different engine or non stock trigger pattern requires purchasing a different firmware license. Multiple firmware licenses can be installed on a single ECU.

  • Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 firmware does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training.

  • This firmware is for closed course competition vehicles only. It does not meet federal emissions requirements.


Related Items